Welcome!

Welcome to the official BlackBerry Support Community Forums.

This is your resource to discuss support topics with your peers, and learn from each other.

inside custom component

Web and WebWorks Development

Reply
New Contributor
just3much
Posts: 3
Registered: ‎01-21-2013
My Device: blackberrry Alpha simulator and blackberry 9300 with OS 7.0
My Carrier: Wind

Installer User Mode Not Supported

Hi All,

 

I am getting error message while installing blackberry 10 SDK.

 

it fails well before step 3. i never get to see introduction screen..getting error message "Installer User Mode Not Supported" ......Installer cannot run in UI mode, To specify the interface mode, use th -i command option, followed by UI mode identifier, The valid UI mode identifiers are GUI, console, and Silent.

 

 

Install the BlackBerry WebWorks SDKfor BlackBerry PlayBook OS

 

  1. Download the BlackBerry WebWorks SDK for BlackBerry Tablet OS from the Downloads page.
  2. In the folder where you downloaded the BlackBerry WebWorks SDK, double-click the installation file.
  3. On the Introduction screen, click Next.
  4. On the License Agreement screen, accept or decline the terms of the license agreement and click Next.
  5. On the Choose Install Folder screen, select a location to install the BlackBerry WebWorks SDK and click Next.
  6. On the Choose Adobe AIR SDK Install Folder screen, select the location where the AIR SDK is installed, and click Next.
  7. On the Pre-Installation Summary screen, click Install.
  8. When the installation completes, click Done to close the installer.
Please use plain text.