02-02-2013 05:18 PM
I attached my cellphone to my PC and I see it charging. I open Blackberrry Desktop Software but it acts like I need to connect my cellphone even though it is already connected. What do I have to do to get the software to recognize my 9800 Torch ?
02-02-2013 05:47 PM
Hi and Welcome to the Community!
Here is the list of troubleshooting articles...hopefully something will be useful:
Also, check that you are using only root USB ports...no hubs (sometimes the front-side ports are hubs...use a rear USB port). And make sure to try disabling USB power management in your system configuration (Device Manager).
Also check on conflicting software...it has been reported that the software package NTI Shadow&Ninja can cause a conflict; removing them and reinstalling the BB desktop software allows it to install correctly.
Apologies in advance if this is redundant -- there's no way to be sure if you've already seen and tried these. Also apologies if any are not presently available...RIM takes them up and down at will as they revise things.
Hopefully something there is helpful!
02-04-2013 10:47 PM
02-05-2013 09:14 AM