Welcome!

Welcome to the official BlackBerry Support Community Forums.

This is your resource to discuss support topics with your peers, and learn from each other.

inside custom component

Java Development

Reply
Highlighted
Developer
Posts: 40
Registered: ‎03-29-2009
My Device: Storm 9550
My Carrier: AT&T

Viewing Logging in the Simulator

At some point, I enabled on-screen (LCD) logging in my device simulator (a 4.5.0 8800, in this case).  Therefore, when I run or debug my app, there is a thin white band shown overlaid at the bottom of my simulator's LCD screen.  Anything my app, or the simulator itself, writes to System.out, shows up in this white band.

 

I originally enabled this with some sequence of clicks within the simulator itself, but I can't for the life of me remember how.  It's now become quite annoying, as it impeded my ability to take good screenshots, or make videos of the running simulator.

 

Does anyone remember how to enable/disable this simulator feature?

 

Thanks in advance.

Developer
Posts: 40
Registered: ‎03-29-2009
My Device: Storm 9550
My Carrier: AT&T

Re: Viewing Logging in the Simulator

Sorry, to clarify, I am using the 8800.bat simulator with JDE 4.2.1, not 4.5.0.
Developer
Posts: 40
Registered: ‎03-29-2009
My Device: Storm 9550
My Carrier: AT&T

Re: Viewing Logging in the Simulator

I also know about using clean.bat to reset the simulator to a "clean" state.  That allows me to turn off this feature, but I'd still like to know how to enable/disable it.