Welcome to the official BlackBerry Support Community Forums.

This is your resource to discuss support topics with your peers, and learn from each other.

inside custom component

Web and WebWorks Development

Posts: 68
Registered: ‎09-29-2009
My Device: Not Specified

How to debug MDS application.

[ Edited ]


         i am new in blackberry mobile development.I created MDS appication(Rapid Applicaion using VS 2008) which has only one label.I want to run this  application but i am getting following error..

Anyone Help me?


[Start BlackBerry MDS-IS] Starting BlackBerry MDS Integration Service...
[Start BlackBerry MDS-IS] DONE!
[Start Debug Session] Connecting to debug port...
[Start Debug Session] DONE!
[Start Debug Session] Wait for debug message listeners to start-up...
[Start Debug Session] DONE!
[Start Debug Session] Send debug handshake request
[Start Debug Session] Wait for handshake response...
[Start Debug Session] DONE!
[Check Device Dependencies] Invalid URI: The URI is empty.

Thanks in Advance..

Pankaj Pareek.

Message Edited by pankajpareek on 10-09-2009 03:08 AM
Posts: 395
Registered: ‎12-18-2008
My Device: BlackBerry Torch 9800
My Carrier: AT&T

Re: How to debug MDS application.

The error is telling you - the endpoint for the service is blank. Perhaps you used a WSDL that didn't have all of the information? You can manually set the URI in the project - I don't remember how to do it in the Visual Studio plug-in but I'm sure the docs will tell you.


This is the forum for Browser development - since you're asking about an MDS Runtime application (there's no such thing as an MDS application) you should probably post your questions to the MDS Runtime Development forum instead - you'll get people there who know more about MDS Runtime development.